|
Channels |
2 channel |
4 channel |
4 channel |
Bus |
PCI , ISA
, PC104 |
PCI ,ISA |
PCI |
Products |
HPCI-CTR522F
HPC-CTR222
HPC104-CTR122F |
HPCI-CTR524F
HPC-CTR224
|
HPCI-CTR544F |
|
Counter length |
32bit binary(-231~+231-1) (-2,147,483,648 ~ 2,147,483,647) |
Counter incoming signal form |
Select 3 forms with software
(1) Phase difference (2 phase) pulse
(2) Up/down individual pulse
(3) direction / pulse sequence |
Count frequency |
Count input signal |
The maximum counter
frequency(CPS) |
The maximum counter
frequency(CPS) |
The maximum counter
frequency(CPS) |
Filter on |
Filter off |
Filter on |
Filter off |
Filter on |
Filter off |
90゜ phase difference signal (1 multiply) |
1.5M |
2.5M |
1.5M |
2.5M |
7.0M |
12.0M |
90゜ phase difference signal (2 multiply) |
3.0M |
5.0M |
3.0M |
5.0M |
15.0M |
22.0M |
90゜ phase difference signal (4 multiply) |
6.0M |
10.0M |
6.0M |
10.0M |
30.0M |
45.0M |
Up/down individual pulse |
3.0M |
5.0M |
3.0M |
5.0M |
15.0M |
22.0M |
direction / pulse sequence |
3.0M |
5.0M |
3.0M |
5.0M |
15.0M |
22.0M |
|
|
|
|
|
|
|
|
Count signal input circuit With a digital filter |
Differential receiver receptacle (about 26LS32) |
|
|
|
Up/down pulse count |
32bit binary Up/down count
- 2phase, Up/down, and
direction / pulse sequence |
Pulse width measurement
(time measurement between edge) |
0.5 Tw 53s
resolution 25ns |
|
0.5 Tw 53s
resolution 25ns |
|
0.4 Tw 42s
resolution 25ns |
|
Only UCTR |
Only YCTR, UCTR |
Only YCTR, UCTR |
Pulse cycle measurement |
Only UCTR |
Only YCTR, UCTR |
Only YCTR, UCTR |
Phase difference measurement |
Only UCTR |
Only YCTR, UCTR |
Only YCTR, UCTR |
counter clear after counter read-out |
Counter automatic clearance after counter read-out |
|
|
MAX-MIN measurement |
Max-mini value measurement at the time of Up/down count |
Comparator function |
number of sets
|
32 bit-length comparator of 4 sets (CMP1~4) |
Comparison result
|
1. A check is possible as status and interruption status.
2. An external output by XYOUT1 and XYOUT2 (ZUOUT1, ZUOUT2) is possible in condition formation. |
Function at the time of condition formation
|
1. Comparison counter clear enable at the time of equal comparison formation.
2. Interrupt Output enable by Condition Formation . |
Window comparator function |
Two-dimensional area comparator enable. |
|
Z phaze (external signal) input |
Counter clear by Z-phaze-input (every per ch one signal), Latch simultaneously by Z-phaze-input (every per ch one signal). |
Simultaneous latch function |
Latch simultaneously by comparator coincidence, z-phaze-input, IN1 input and the event timer. |
Individual latch function |
Latch each ch by ch Z-phaze input. |
Event timer function
Function for every cycle
|
IRQ interruption output the whole cycle is possible by the periodic interruption timer.
(
Output pulse width is
10104(~128)msec) |
Interruption cycle 20 .s - 167.77215sec |
Interruption cycle 20 .s - 167.77215sec |
Interruption cycle 20 .s - 335.5443sec. |
Latch of the contents of XCTR and YCTR(or ZCTR, UCTR) enable for every cycle.
Or counter clear enable after latch.
(However, CombinationXCTR, YCTR (or ZCTR, UCTR))
External output the whole cycle enable. |
|
|
Coupler insulation general-purpose input and output |
4IN/4OUTDIO port |
Input port |
Input logic : set '1' at the time of the input photo-coupler ON. |
Rated input voltage : DC12V~DC24V
Used input voltage range : DC10V~DC28V |
Rated input voltage : DC12V~DC24V
Used input voltage range : DC10V~DC28V |
Rated input voltage :
DC5V
Used input voltage range : DC5V |
Rated input : 8mA / point |
Output port |
Output logic : At the time of '1' , writing Output ON |
Rated load voltage :DC5V~DC24V |
Rated load voltage :DC5V~DC24V |
Rated load voltage :
DC5V |
Load current :5mA or less/point |
Match output(XYOUT1,XYOUT2) |
Output form : Photo-coupler insulation open collector output |
Output rating :DC5V~DC24V,5mA/point |
Output rating :DC5V~DC24V,5mA/point |
Output rating :DC5V,5mA/point |
Coincidence signal output width : 50,1ms,6.25ms,104ms |
Event timer output
(XYOUT2,ZUOUT2) |
External output for every event timer cycle
Setup software |
|
|